A collection of all cylinder information.
Marked on both diagrams, it is marked for the larger link pictures that is needed for this unit. Helps in setting the adjustment for the controller. If you need your controller repaired or need a new controller, we can assist you with that. We provide HDC, EDC and MDC controllers. So give us …
If you need more info on this unit or any of the Dynapower Models, call us at 800-361-0068 sales@htsrepair.com
If you need more info on controls or any Racine pumps and motors, call us at 800-361-0068 or 662-871-8403 tupelohydraulics@gmail.com or sales@htsrepair.com
If you need more assistance with this unit or any others, call us at 800-361-0068 sales@htsrepair.com
PVF-PSTO-12* *-01 P = Higher Standard Compensator S= look for the diagram for screw volume control B,C,E = look on the diagrams below for parts list for springs R,L,D = see which letter matches up with the letter on your pump code. *goes with bodies 221458 and 221581 only chart on the right …
A. Put in two dowel pins and a gasket on the end cover, make sure to put grease on the bearing shims and cup before you put them in the end cover. B,D & E. You will need to look at the end play of your output drive shaft. Put in the end cover so …
Eaton Fixed Displacement Motor Series 33 thru 64 Read More »
Limit of viscosity rangeFor operating applications you will need to follow these guidlines:nmín = 60 SUS (10 mm2/s) for not so long periods (t £ 1 min) at max. perm. The fluid temperature of 239 °F (115 °C). Make a note that the max. leakage fluid temperature of 239 °F (115 °C) doesn’t go …
If you need more info on the 90 Series, give us a call at 66-2871-8403 or 800-361-0068 tupelohydraulics@gmail.com
If we can assist you with answering questions or repairing your unit, call us at 800-361-0068 sales@htsrepair.com
Swashplate hold down pin and motor shaft changes. If you need further assistance with this or any Sundstrand Pump and Motor, call us at 662-871-8403 or 800-361-0068 tupelohydraulics@gmail.com sales@htsrepair.com